Short design and freely usable cooling pins.
Is perfect as a landing / taxi light on landing gears and landing gear flaps.
Direct operation with 2S LiPo (8V), with 3S (12V) the enclosed additional resistor must be soldered in or a 4W adapter cable (accessory) must be used.
Please ensure that there is sufficient cooling air during operation.
Without any further flow, the spotights should only be operated 2-3 minutes at a time, with cooling pins 5-6 minutes.
Direct mounting on a landing gear leg is recommended.
Power: 2x4W reference power Voltage: 2S/8V and 3S/12V Current: 0.35A Radiation angle: ~110° Light output: 2x100 Lumen WHITE Light output: 2x95 Lumen WARMWHITE Dimensions: D12x10mm, cooling bolt D7x15mm Weight: about 10g (without wire) Wi th 1m silicon cable, ready to use at 2S/8V Lipo, optionally with included resistor for 3S LiPo With the X2 technique high power LEDs are operated in a "cluster".
These achieve double the light output for the same heat or the same light output at half heat dissipation.
Yet our X2 lights are still fully compatible with all our other lamps.
If X2 lights, such as spotlights, are supplied with separate cables, these cables must be used in the delivered wiring! X2 lights are reacting more strongly on a weakening battery.
The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION
Notify me when available
We will send you a notification as soon as this product is available again.
We don't share your email with anybody