PRO11X-040-RT
$ 20.00
The profile light of the 11mm series is slim outside and fits optically also onto smaller models.
In delivery state, the profiled polycarbonate cap is simply attached.
It can be varnished separately.
It's highly transparent and unbreakable.
Electricity: 4W reference power, 8(12)V, 0.35A Beam angle: >160° Light intensity: 50 Lumen RED Light intensity: 80 Lumen GREEN Light intensity: 100 Lumen WHITE Dimension assembly pin: 33x5*60 Dimension light cap: 11.5x42.5x10mm, up to 4mm lowerable without loss of beam angle Total mass: 11.5x70x35mm Weight: 8g (without cable)Ready to use with 1m silicon cable and series resistor for 2S, resistor for 3S enclosed The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. The luminaire is ready to use for operation with 2S LiPo (ca.
8V).
With 3S (12V), the enclosed resistor has to be added.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.
If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION
