STRB19-140x2-WE
$ 35.00
Please make sure to operate the chip only in flash mode and with sufficient cooling.
Electrical: 14W reference power with x2 technology, 8V / 12V, 1.2A Beam angle: 120 ° Light intensity: ~ 450 lumens RED Light intensity: ~ 1000 lumens WHITE Dimension: D19x2mm Weight: 2g (without cable)With 1m silicone connection cable, ready for connection to 8V / 2S Lipo.
Additional resistance for operation with 12V / 3S Lipo The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. The luminaire is ready to use for operation with 2S LiPo (ca.
8V).
With 3S (12V), the enclosed resistor has to be added.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.
If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION
