DUALGLASSF-120x2-GNWE
$ 44.00
Each lamp is realized in UltraPower technology and is controlled separately for independent operation.
Reasonable but very high power solution for mounting behind existing glass caps in Viperjet, high-wing aircrafts, ...
The module is being delivered completely prewired on an aluminium heatsink.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
In delivery state, these lamps are only suitable for normal operation from 5 to 10 minutes when paying attention to a slight air flow.
Please check operation temperatures after installation and ensure sufficient air cooling.
Integrated temperature fuse will protect the light against massive overheating.Electricity: 8W reference power, 8(12)V, 0.7A and 4W reference power, 8(12)V, 0.35A Beam angle: ~160° Light intensity: ~100 Lumen RED Light intensity: ~140 Lumen GREEN Light intensity: ~400 Lumen WHITE Dimension plate: 24x23mm, 24x26mm, 1.5mm white Weight: 10g (without cable)Ready to use with 1m connection cable and series resistor for 2S, resistor for 3S enclosed The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. The luminaire is ready to use for operation with 2S LiPo (ca.
8V).
With 3S (12V), the enclosed resistor has to be added.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.
If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION
