GLASS-040-WE
$ 18.00
The module is being delivered completely prewired on an aluminium heatsink, mounting material inclusive.
For mounting, drill a small hole and insert the cooling pin.
After that, the mounting flange can be screwed from the outside.Electricity: 4W reference power, 8(12)V, 0.35A Beam angle: ~160° Light intensity: ~40 Lumen RED Light intensity: ~70 Lumen GREEN Light intensity: ~100 Lumen WHITE Dimension base plate : 13x20x7mm Dimension heatsink: D10x25mm Weight: 3g (without cable)Ready to use with 1m connection cable and series resistor for 2S, resistor for 3S enclosed, mounting screws The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. The luminaire is ready to use for operation with 2S LiPo (ca.
8V).
With 3S (12V), the enclosed resistor has to be added.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.
If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION
