10,24mm ROUND Navigation Light, 4W

RND-040-WE

$ 18.00


Next Previous


4W point light with three transparent polycarbonate caps (10mm and 24mm).

The module is delivered completely wired-up on an aluminium retaining plate for cooling and mounting.

Another small heatsink for an alternative mounting with the smallest dimensions is included.

You only have to glue on the desired cap and heatsink with superglue.

The 10mm cap serves as light distribution concerning the concealed installation behind a GFK wall.

The 24mm cap can be used for external installation for it completely covers the module.

The accessory includes a profile expansion, which can be optionally glued on the 10mm cap.Electricity: 4W reference power, 8(12)V, 0.35A Beam angle: ~160° Light intensity: ~40 Lumen RED Light intensity: ~75 Lumen GREEN Light intensity: ~100 Lumen WHITE Dimension base plate: 10x50mm Dimension additional heatsink: 15x15x6mm, self-adhesive Small cap: D10x12mm + profile expansion Big cap: D24x10mm Weight: 6g (without cable)Ready to use with 1m connection cable and series resistor for 2S, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION