4mm FIBER Strobe Light, 8Wx2

The luminaire consists of a full aluminium power section, a glass fiber with reflective jacket and end caps.Electricity: 8Wx2 reference power, 8(12)V, 0.35A Beam angle: >160° Light intensity: ~50 Lumen RED Light intensity: ~100Lumen WHITE Dimensions: D10/12mm, 45mm length Fiber: 4mm with jacket, piece of 200mm Weight: 7g (without wire)Ready to use with 1m silicon cable and series resistor for 2S, resistor for 3S enclosed, end caps The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION