POINT-003-SET
$ 22.00
The luminaire gets hardly hot, it only needs a few milliamperes and is ideal for use in smaller models like helicopters and styrofoam models (up to about 1m).
It's also suitable for night flights.
The set contains: 1x RED + 1x GREEN for Position light 1x RED for Beacon light 2x WHITE for ACL Flashlights or Landing light Resistor for 6-12V operation 3m connection cable Insulation material Electricity: 0.3W reference power, 8/12V, 5x0.03A Beam angle: 18-25° Light intensity: ca.
2-4 Lumen Dimension: D5x10mm (without cable) Weight: 1g (without cable) The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. The luminaire is ready to use for operation with 2S LiPo (ca.
8V).
With 3S (12V), the enclosed resistor has to be added.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.
If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION
