DUAL Strobe Light Module, 60Wx3

STRB10-600x3-WE

$ 71.00


Next Previous


DIY double strobe series as a replacement for flash tubes Extremely powerful strobe chips in a double-row design with numerous high-power chips.

The design makes it ideal for use as a tube replacement in tail units or nose strips.

The light may only be operated with short strobe pulses without further cooling.

Reliable visibility over many hundreds of meters, on both sides of the model! Electric: 60W reference power with x3 technology, 12V only, 5.0A Beam angle: ~ 2x120 ° Light intensity: ~ 7000 lumens WHITE Dimension: 8x18x50mm Weight: 7g (without cable)With 1m silicone connection cable, ready for connection to 12V / 3S Lipo The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION