12mm Triple-Spotlight, 3x2W

The spotlight is perfectly suitable for high-performance spotlights on small viperjets (~1,5m) and similar models; guaranteed to be visible at daylight for over a hundred meters.

The wide beam angle coupled with an enormous performance make these spotlight a topmodel! Direct operation with 3S LiPo (12V).

Please ensure sufficient cooling air during operation.

For the first time in model making, the spotlights are equipped with an integrated overtemperature protection .

If the enclosure becomes too warm, the light will be safely switched off.

Without any further cooling, do not operate such spotlights more than 3-5 minutes at a time.

Otherwise, the protection will switch off the light or let it blink.

Power: 3x2W reference power Voltage: 2S/8V and 3S/12V Current: 0.45A Radiation angle: ~110° Light output: 3x60 Lumen WHITE Light output: 3x55 Lumen WARMWHITE Dimensions: 12x42x9mm Mounting size: 12x60x9mm Cooling bolts: 3x15 (use thin CA glue) Weight: ca.

15g (without wire) Wi th 1m silicon cable, ready to use at 2S/8V Lipo, optionally with included resistor for 3S LiPo With the X2 technique high power LEDs are operated in a "cluster".

These achieve double the light output for the same heat or the same light output at half heat dissipation.

Yet our X2 lights are still fully compatible with all our other lamps.

If X2 lights, such as spotlights, are supplied with separate cables, these cables must be used in the delivered wiring! X2 lights are reacting more strongly on a weakening battery.

The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.

Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION