12mm Double-Spotlight, 2x4W

Double spotlights with very compact, CNC-machined aluminum reflectors.

Short design and freely usable cooling pins.

Perfect as a landing/taxi light on landing gear and landing gear flaps.

  Direct operation with 2S LiPo (8V); with 3S (12V), the enclosed additional resistor must be soldered in, or a 4W adapter cable (accessory) must be used.

Please ensure that there is sufficient cooling air during operation.

Without any further airflow, the spotlights should only be operated for 2-3 minutes at a time, with cooling for 5-6 minutes.

Direct mounting on a landing gear leg is recommended.

Power: 2x4W reference power Voltage: 2S/8V and 3S/12V Current: 0.35A Radiation angle: ~110° Light output: 2x100 Lumen WHITE Light output: 2x95 Lumen WARMWHITE Dimensions: D12x10mm, cooling bolt D7x15mm Weight: about 10g (without wire) Wi the 1m silicon cable, ready to use at 2S/8V LiPo, optionally with included resistor for 3S LiPo With the X2 technique high power LEDs are operated in a "cluster".

These achieve double the light output at the same heat, or the same light output at half the heat dissipation.

Yet our X2 lights are still fully compatible with all our other lamps.

If X2 lights, such as spotlights, are supplied with separate cables, these cables must be used in the delivered wiring! X2 lights react more strongly to a weakening battery.

The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S LiPo and is dependent on bulbs, operating mode, and technology.

Always pay attention to the operating temperature; we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION