SPOT14F-080x2-WE
$ 39.00
CNC-manufactured aluminum reflector with 14mm diameter, built-in temperature fuse, optimized for performance and weight, these headlights already have built-in optics. Direct operation with 2S (8V) Lipo, with 3S (12V) the enclosed additional resistor must be soldered in.
Make sure there is sufficient cooling air during operation.
For the first time in the model construction sector, the headlights have an integrated excess temperature fuse.
If the housing becomes too warm during operation, the light is switched off safely and safely.
Such headlights can only be operated for approx.
3-4 minutes at a time without further cooling, then we switch off the fuse or let the light flash.
Performance: 8Wx2 reference power Overtemperature protection: switch-off and clocking of the light at 65-70° Voltage: 2S/8V (3S/12V), use enclosed resistor additionally for 12V! Electricity: 0.65A Beam angle: ~30°/~90° Light intensity: ~590 Lumen WHITE Light intensity: ~590 Lumen WARMWHITE Dimension: D14x52mm, mounting hole D10mm Weight: 6g (without cable) R eady to use with 1m connection cable for 3S operation With the X2 technique high power LEDs are operated in a "cluster".
These achieve double the light output for the same heat or the same light output at half heat dissipation.
Yet our X2 lights are still fully compatible with all our other lamps.
If X2 lights, such as spotlights, are supplied with separate cables, these cables must be used in the delivered wiring! X2 lights are reacting more strongly on a weakening battery.
The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION
