LGC22HD20
$ 78.00
Controller and sequencer for electric landing gears including terminal
Control by Single channel (Gear operation and brake operation combined on a single channel) or separate channels for gear and brake.
Control 3 landing gears. Programmable independent delay for each gear in UP and DOWN sequence.
Control of electric brake:
Control of steering servo: Allow to use the same channel as the rudder, despite of different center, travel gain, and direction on the steering servo than the rudder servo. The steering servo center, travel, and sense of movement can be adjusted.
The steering servo is centered and deactivated during gear operation and gear UP phase.
Door control output:
Servo Switch-off. Door servos can be deactivated after movement to prevent the posibility of servo burnout on a jammed door. Deactivation time can be programmed.
Manual mode:
Allow to cycle the gear manually for testing during the setup phase, movement can be stopped and resumed in any position.
Allow to move the motors independently in any direccion and stop in any position for check clearance, etc.
Motor setup:
Motor cut-off current and timeout time can be adjusted up to 2,5 A /30 s.
Cycle counter for scheduled maintenance.
Easy setup:
Data terminal included.
Connecting leads included.
IMPORTANT:
The motors on the retract can be damaged if overloaded due to improper programming. For this reason, Xicoy WILL NOT provide any settings for any brand, all information provided is the one contained in the user's manual. Always contact the manufacturer of the retracts to get the proper settings for your gear.
Instructions:
