12mm DUAL Navigation + Strobe Light, 10Wx2,SHORT


$ 45.00

Very compact and powerful navigation light of the 12mm series with integrated flash!   A new, angled design enables the position light to be optimally emitted to the front and the flashlight to the side.

Best visibility and low glare as with the models.

The extremely short design can also be easily integrated in small models and where space is very limited.

  The scope of delivery includes a highly transparent and extremely break-proof cover cap made of injection-molded polycarbonate.

The cap must be glued to the light module on the model.

Electricity: 3.5Wx2 RED/GREEN und 7.5Wx2 WHITE reference power, 8V/12V Energy: 0.3ARED/GREEN, 0.6A WHITE Beam Angle: >160° Light intensity: ~70 Lumen RED Light intensity: ~150 Lumen GREEN Light intensity: ~600 Lumen WHITE Total Mass: 12x14x21mm weigth: 2g (without Kabel)Ready to use with 1m silicon cable and series resistor for 2S operation, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.


With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION