24mm DUAL Navigation + Strobe Light, 12Wx2, T-Fuse


$ 47.00

A white 8Wx2 flashlight and a 4Wx2 position light combined in a housing with integrated cooling surfaces.

Both lights are individually controlled and thus ideally suited for the combined operation as position and flashlight.

An integrated overtemperature protection switches off the system in case of overheating.

The luminaire is delivered as a ready assembled unit on an aluminium cooling plate and a changeable polycarbonate cap as covering.

The luminaire is ready to use for 2S Lipo (ca.

8V) operation.

With 3S (12V), the enclosed resistor has to be used.

Alternatively use a 4W-3S and a 8W-3S adapter cable.Electricity: 8W reference power, 8(12)V, 0.7A and 4W reference power, 8(12)V, 0.35A Beam angle: >160° Dimension base panel: 24x75x9mm Thickness assembly plate: 2mm Luminous flux: 2x50 Lumen RED Luminous flux: 2x70 Lumen GREEN Luminous flux: 2x200 Lumen WHITE Weight: 15g (without cable)Ready to use with 1m connection cable and series resistor for 2S, resistors for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.


With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION