8mm MINI Navigation Kit, 3,5W


$ 39.00

Set for the do-it-yourself construction of cost-effective and small navigation lights in a short version with slightly reduced performance.

Ideal for smaller models but still great luminosity.

The set consists of two lights with heatsink and caps, a bunch of cables, resistors for operation with 6V, 8V(2S) and 12V(3S).

The lights only have to be wired in the model.Electricity: 3.5W reference power, 8(12)V, 0.28A Beam angle: >160° Light intensity: RED ~40 Lumen, GREEN ~60 Lumen Dimension cap: 8x18x9 Dimension cooler: D7x14 Weight: 5g (without cable)2m cable, series resistor for 6V, 2S and 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.


With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION