8mm MINI Navigation Light, 2Wx2, SHORT


$ 23.00

The short version of the miniature navigation light with 2W reference power for small models on thin wings, air inlets or ideally on Styrofoam models.

The mini light is delivered as a fully assembled unit on a CNC-manufactured aluminum heat sink and an enclosed polycarbonate cap as a cover.

The cap is specially made to diffuse the light for better visibility, this must be glued on during installation.Electricity: 2Wx2 reference power, 8(12)V, 0.16A Beam angle: >160° Light intensity: ~50 Lumen RED Light intensity: ~70Lumen GREEN Light intensity: 125 Lumen WHITE Dimension cap: 8x18x9 Dimension cooling pin: D7x14 Weight: 2.5g (without cable)Ready to use with 1m silicon cable and ready made series resistor for 2S, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.


With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION