8mm MINI Strobe Light Kit, 8W



Set for the do-it-yourself construction of cost-effective and small 8W flashlights in a short version.

Ideal for smaller models with great luminosity.

The lights may NOT be operated individually, but via the enclosed x2-cable.

The set consists of two lights with heatsink and caps, a bunch of cables, one x2-cable, already prepared resistors for operation with 8V(2S) and another resistor for 12V(3S).

The lights have to be wired.Electricity: 8W reference power, 8(12)V, 0.7A Beam angle: >160° Light intensity: ~200 Lumen every luminaire Dimension cap: 8x18x9 Dimension cooler: D7x14 Weight: 5g (without cable)2m cable loose, x2-cable with series resistor for 2S, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.


With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION