New generation of compact and very powerful position lights with integrated flash! The new, forward-angled structure enables the best radiation of the position light to the front and the flashlight to the side.
Best visibility and low glare like the original.
The extremely small design can also be integrated in small models and large scales.
The scope of delivery includes a highly transparent and extremely break-proof cover cap made of injection-molded polycarbonate.
The cap must be glued to the light module on the model.
Electricity: 6Wx2 RED/GREEN and 14Wx2 WHITE reference power, 8(12)V Electricity: 0.5A RED/GREEN, 1.4A WHITE Beam angle: 0 to 120° RED/GREEN, 60° to 180° WHITE Light intensity: ~160 Lumen RED Light intensity: ~250 Lumen GREEN Light intensity: ~1000 Lumen WHITE Dimension: 6.5x55x60mm Weight: 18g (without cable) With 1m silicone connection cable, already mounted with high quality polycarbonat cap The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. The luminaire is ready to use for operation with 2S LiPo (ca.
With 3S (12V), the enclosed resistor has to be added.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.
If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION