FLAT DIY Navigation Light, 2Wx2

GLASS-020x2-WE

$ 19.00


Special light for DIY applications.

Extremely flat and powerful for usage in very hard accessible areas.

Perfect for mount in thin rudders, rocket carrier, jet wing tips,...

The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

This lamp is delivered with optional heatsink which must be used for long operation but is not necessary for strobe operation.

  Electricity: 2Wx2 reference power, 8(12)V, 0.25A Beam angle: >150° Light intensity: ~80 Lumen RED Light intensity: ~140 Lumen GREEN Light intensity:~180 Lumen WHITE Dimension: 35x5x2mm Weight: 1g (without accessories)Ready to use with 0.5m PTFE cable, two optional heatsinks/mounting plate, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION