FLAT Navigation Light, 4W

FLAT-040-WE

$ 18.00


Very low installation light for mounting behind existing glazing on thin wings, tail units or with a cap for flat, small installation on the fuselage inner wall of jets and helicopters.

The waste heat is dissipated in the assembly level on a special aluminum core PCB, which is why these lights have only 7mm height.

The scope of delivery includes an optional, self-adhesive heat sink and mounting screws.

The heat sink can be placed below or above, depending on space, for longer periods of operation.Electrical: 4W reference power, 8 (12) V, 0.35A Beam angle: ~ 160 ° Light intensity: ~ 50 lumens RED Light intensity: ~ 80 lumens GREEN Light intensity: ~ 100 lumens WHITE Dimension of flat light: 16x32x7mm Dimension additional heat sink: 15x15x6mm Dimension cap: 8x8x18mm Weight: 5g (without cable)Ready to use with 0.5m PTFE cable, two optional heatsinks/mounting plate, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION