FLAT Navigation Light double, 2x4W


$ 33.00

Two flat recessed light for direct mounting behind existing glazing on thin wings or tail units.

Optimal light output on the top and bottom side.

The waste heat on the mounting level is dissipated on a special aluminium core PCB, which is why these lights only have a 7mm headroom.

The scope of delivery contains two optionally usable, self-adhesive heatsinks and mounting screws.

For longer operation time, the heatsinks can be placed underneath or above, depending on the space available.

The lights are wired ready for operation and can be mounted in different distances with accessories provided.Electricity: 2x4W reference power, 8(12)V, 0.35A Beam angle: ~160° Light intensity: ~2x50 Lumen RED Light intensity: ~2x75 Lumen GREEN Light intensity: ~2x100 Lumen WHITE Dimension flat light : 16x32x7mm Dimension additional heatsink: 15x15x6mm, 2 items Weight: 10g (without cable)Ready to use with 1m connection cable and series resistor for 2S, resistor for 3S enclosed, 2 heatsinks, mounting screws and spacer The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.


With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION