FLAT Strobe Light, 8Wx2, T-Fuse

FLATF-080x2-WE

$ 33.00


Extremely powerful and compact flat light for installation behind existing glass moldings on thin vanes or tail units.

Version in the powerful x2 technology with integrated thermal fuse.

The module is delivered ready wired on an aluminum core PCB, which is why these lights have only 7 / 9mm height.

The scope of delivery includes two optional, self-adhesive heatsinks and mounting screws.

The heat sinks can be placed below and / or above, depending on space, for a longer service life.

Elektrisch: 2x4W Referenzleistung, 8(12)V, 0.7A Abstrahlwinkel: ~160° Lichtstärke: ~200 Lumen ROT Lichtstärke: ~300 Lumen GRÜN Lichtstärke: ~400 Lumen WEISS Abmessung Flachlicht: 16x32x9mm Abmessung Zusatzkühlkörper: 15x15x6mm, 2 Stück Gewicht: 8g (ohne Kabel) Ready to use with 0.5m PTFE cable, two optional heatsinks/mounting plate, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION