10mm PIN Navigation Light, 3Wx2, SHORT

PIN10X-030x2-RT

$ 26.00


Short high-performance light with 3Wx2 reference power as navigation light on small and medium-sized models.

The penlight is delivered pre-assembled and ready for use on a CNC-manufactured aluminum heat sink, with 5 high-strength polycarbonate caps for free use: 1x 10mm cylinder cap 1x 10mm round cap 1x 13mm cylinder claw 1x 13mm round cap and 1x profile extension 10mm The caps can be glued separately and individually painted in the same color as the model.

Any adhesive that does not evaporate is suitable for bonding, such as epoxy, Uhu Allplast, Uhu Por, silicone, canopy glue, ...

Ideal as a flash on smaller Styrofoam models and helicopters ...

Electricity: 3Wx2 reference power, 8(12)V, 0.2A Beam angle: >160° Light intensity: ~70 Lumen RED Light intensity: ~100 Lumen GREEN Light intensity: ~200 Lumen WHITE Total Dimension: D10x37mm, flange D12mm Dimension heatsink: D10x25mm Weight: 4g (without cable) Ready to use with 1m silicon cable and series resistor for 2S, resistor for 3S enclosed, profiled expansion cap The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION