$ 199.99

Auto-Air-fill (onboard compressor)

Vspeak Auto-Air-fill is an only ~220g light onboard compressor for pneumatic chassis mechanics, brakes, etc.

The pressure range can be adjusted as well as some other parameters. Once set, the desired pressure range is regulated fully automatically.

A previously required pressure reservoir can be significantly reduced - or it can be dispensed with entirely.

IMPORTANT: When air is compressed, heat is generated, with high pressures and long-running times of the onboard compressor correspondingly a lot of heat. We, therefore, recommend using a Teflon hose (outer diameter 4mm) as the direct compressed air connection. We highly recommend using a good quality Teflon tubing 4mm OD you can get it HERE

There are several operating modes for Auto-Air-fill:

  • Autonomous Automatic mode (remote control independent)
  • Automatic mode Servoport (requires a servo output to which a 3-position switch has been programmed)
  • Automatic mode Telemetryport (only with Jeti and PowerBox core: Telemetry data are transferred)


The onboard compressor can be ordered as a complete unit (see picture above, which can vary depending on the compressor used), in this case, the pressure sensor is also calibrated.


Detailed information about VSpeak Auto-Air-fill can be found in the detailed manual.

Customer Reviews

Based on 2 reviews Write a review