The power model of the new generation of compact 12mm position lights with integrated flash and temperature fuse! The new, forward-angled structure enables the best radiation of the position light to the front and the flash light to the side.
Best visibility and low glare like the originals.
The small design can also be easily integrated into models with a large scale.
Electricity: 7Wx2 RED and 12Wx2 WHITE reference power, 8(12)V, 0.6A RED/GREEN, 1A WHITE Beam angle: 0 bis 120° RED/GREEN, 60° bis 180° WHITE Light intensity: ~150 Lumen RED Light intensity: ~280 Lumen GREEN Light intensity: ~800 Lumen WHITE Total mass: 12.5x38x60mm Weight: 13g (without cable)Ready to use with 1m silicon cable and series resistor for 2S operation, resistor for 3S enclosed The reference power is a comparison value between our offered lights.
It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. The luminaire is ready to use for operation with 2S LiPo (ca.
With 3S (12V), the enclosed resistor has to be added.
Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.
These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.
If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION