8mm MINI Strobe Light,4W, SHORT

MINIX-040-WE

$ 22.00


The short version of the miniature high-performance light with 4W reference power for smaller models, on tail fins, thin wings or also on styrofoam models.

The mini luminaire is delivered as a ready assembled unit on a CNC manufactured aluminium heatsink and an enclosed polycarbonate cap as covering.

The cap is especially designed to scatter light for better visibility.

It has to be glued on during installation.Electricity: 4W reference power, 8(12)V, 0.35A Beam angle: >160° Light intensity: ~50 Lumen RED Light intensity: ~80Lumen GREEN Light intensity: 100 Lumen WHITE Dimension cap: 8x18x9 Dimension cooling pin: D7x14 Weight: 2.5g (without cable)Ready to use with 1m silicon cable and ready made series resistor for 2S, resistor for 3S enclosed The reference power is a comparison value between our offered lights.

It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.  The luminaire is ready to use for operation with 2S LiPo (ca.

8V).

With 3S (12V), the enclosed resistor has to be added.

Please note that high-performance LEDs can get very hot, up to 70°C is quite normal.

These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible.

If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.

Note: The LED lights are extremely bright! Never look directly into a LED! TECHNICAL INFORMATION CONNECTION